DATA LOSS

Data logger in today’s world is no alien technology. Over some time, they have become quite popular due to their functionality and features. Using various sensors to receive the information, data loggers monitor and record environmental parameters over time, allowing conditions to be measured, documented, analyzed, and validated to be stored on a computer. From studying an automobile to understanding its faults to store its behaviour on a chip, a data logger does it all. While using it, one feels that they have access to each bit of information that the vehicle is providing. What if we told you that is not the case.

To know more on our products:

Data Loss stress.png

Many data loggers suffer from a drawback that can be fatal while recording a vehicle’s parameters, “data Loss”. Yes, data loss. Have you ever wondered, what if the data that you see on your loggers is not complete? What if there is the slightest probability that the data logger could not deliver something that your vehicle had put out there? Have you ever checked it?

When you see certain data on your data logger, what if while accessing it you lost some critical information? Data loss could be catastrophic and drain your money and energy unnoticed.   Well, truth be told there are high chances this happens, but no one thinks of it or notices it. But many reasons may be causing it, such as

  • Increased bus load/traffic.

  • Poor quality of memory device or throughput cable.

  • Improper bit timing, wrong sampling rates, or under-sampling.

  • Improper CAN bus termination or improper CAN bus length.

  • Lack of isolation.

  • Chip overloading.

  • Technical problem with the logger itself

  • Complete logger failure or user error

  • data has become corrupted

  • Data overwritten by another file or corrupted data

data loss on fire.jpg

So, if there are so many conditions that tend to generate data loss, then definitely the data being logged is not correct, or one might have missed an important event without knowing or even noticing how much of it has been lost. Sadly, there is not much one can do to detect these losses except a few tests, or you put your faith in a trusted brand or valid tests. Without such tests, there is no other way to confirm what and how much data was lost.

data loss solution.jpg

What if you had a solution that enabled you to overcome all these situations and provide you with data with nil or minimum loss? At “influx”, it has been tested and proved that our data loggers provide optimum results without any losses. As at Influx, we take utmost care of this issue, ‘data loss”. This experimented and validated through our in-house “replay system” where each and every message is played back repeatedly, making sure there is practical “loss of data”. When tested, products from “influx” it was confirmed that there was no data loss even with maximum data load. Our microchip is ultra-powerful, hence no data losses due to overloading, whereas it was found to be as high as 40-50% in some competitor products. Make sure you don’t end up picking up a cheap product without noticing the fine prints. It may save money, but ultimately it is a severe loss to your development programme. 

To know more on our products:

Was this article helpful?Don’t love itNot greatGoodReally goodLove itWas this article helpful?

Your content has been submitted